|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-25-2013, 02:25 PM
|
#1 |
|
17's too small
Join Date: Oct 2004
Location: Las Vegas, NV
Posts: 335
|
Porterbuilt front dropmember steering notch
I have the newest (V4) Porterbuilt front extreme dropmember and am trying to install it this weekend. I am unsure as to exactly where to put the notches for the rack and pinion. The directions read:
When running a Dropmember Extreme, the center-line of the rack notch will be located 4.25” forward of the front most mounting hole of the lower cross-member assembly (this is on the BOTTOM of the framerail… see picture below) When running a C4 Dropmember, the center-line of the rack notch will be located 3.5” forward of thefront most mounting hole... Is that a typo (C4)? I have a call and text message in to Porterbuilt but just incase I dont get a reply I was hoping someone here has already installed a V4 and knows the answer. Thanks, John
__________________
68 C10 SWB SS 5 lug power disc brake conversion 2.5 inch drop spindles van tilt column Air Ride Technologies Cool Ride air bag kits Performance Online tubular upper control arms and shock relocator kits ECE super track panhard bar 1 piece side windows |
|
|
|
01-25-2013, 02:37 PM
|
#2 |
|
Registered User
Join Date: Dec 2012
Location: Mesa, AZ
Posts: 276
|
Re: Porterbuilt front dropmember steering notch
Id be interested in this too cause i got a v4 on the way lol...post in here if you find out man.
|
|
|
|
|
01-25-2013, 04:44 PM
|
#3 |
|
Registered User
Join Date: Aug 2010
Location: AZ
Posts: 3,069
|
Re: Porterbuilt front dropmember steering notch
The C4 is in reference to the drop member they manufacture that uses C4 corvette arms, spindles, hubs, etc. I am guessin the setup is a little different and positions the rack differently as well.
Posted via Mobile Device |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
