|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-26-2013, 05:08 PM
|
#1 |
|
Registered User
Join Date: Jan 2011
Location: Chattanooga, TN
Posts: 1,108
|
Question Installing Wilwood Proportioning Valve
I want to install the Wilwood Proportioning Valve in the photo below in the stock location beside the Master Cylinder. If I could locate a brake fitting adapter it would make installation a lot easier.
I need an adapter that has a 1/8" - 24 male (goes in the bottom of the valve marked "RO") to a 5/16" female (original rear brake line). This would allow me to use my original brake lines under the proportion valve in the original position. I have searched Summit, Jegs and tried calling Wilwood's Tech line (on hold for 20 minutes, never got through). I know I could bend up a new line, but there has to be an adapter out there somewhere. Any help would be appreciated. Thanks, POP
__________________
2016 RAM Laramie HEMI 1966 Fairlane GT/A, 390/335 HP If it costs you a dollar to make a friend, KEEP THE DOLLAR. If it costs you a friend to make a dollar, KEEP THE FRIEND. |
|
|
|
04-26-2013, 05:19 PM
|
#2 |
|
Registered User
Join Date: Aug 2009
Location: Concord, CA
Posts: 147
|
Re: Question Installing Wilwood Proportioning Valve
Look at the last post of this thread.
http://67-72chevytrucks.com/vboard/s...d.php?t=558663 |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
