The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1967 - 1972 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 12-22-2013, 07:21 AM   #1
BBrendal
Recalculating.....
 
BBrendal's Avatar
 
Join Date: Nov 2010
Location: New Lenox Il
Posts: 686
Where does this go?

I am putting my duct work back in my 72 Blazer with A/C and can not figure out for the life of me where this connector connects to. The high blower relay, fan speed switch and A/C switch are all connected. Anyone?



__________________
Brian - (BBrendal)

1969 Chevy Camaro Z28
1972 Chevy Blazer CST
2004 GMC Yukon (The truck that pulls the car trailer)
1972 Chevy Blazer CST #2 (Finished and sold!)

Blazer build link...
http://s1213.photobucket.com/albums/...rendal/Blazer/
BBrendal is offline   Reply With Quote
Old 12-22-2013, 07:58 AM   #2
jjzepplin
Registered User
 
jjzepplin's Avatar
 
Join Date: Feb 2012
Location: Ruskin Florida
Posts: 4,566
Re: Where does this go?

There is a resistor inside the heater box that looks like a spring or something. I think it may go to that.
__________________
70 swb 4x4 406sbc 700r4 203/205 d60/14blt locker yadda yadda http://67-72chevytrucks.com/vboard/s...88#post6935688 Yeller
72 Blazer 2wd conversion project "No Daggum Money" http://67-72chevytrucks.com/vboard/s...d.php?t=550804 LS1-T56 3.73 LSD super budget build
Blanco-2014 Sierra SWB https://67-72chevytrucks.com/vboard/...d.php?t=810350
jjzepplin is offline   Reply With Quote
Old 12-22-2013, 10:26 AM   #3
JimKshortstep4x4
Senior Member
 
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
Re: Where does this go?

The wiring connector is for the Anti-Dieseling Relay. If you don't have the solenoid on your carburetor with the connecting wiring you will not need it. The relay would normally be on the inside lower lip of the dash close to the controls.

Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end
1965 Impala SS 400 sbc, Muncie rock crusher
1966 Impala SS 396 bbc, TH 400
1969 El Camino, 350 sbc, TH 350
1971 Snowplow built on a Blazer frame
1972 GMC Short bed, stepside, TH 400, 427 BBC
JimKshortstep4x4 is offline   Reply With Quote
Old 12-22-2013, 12:18 PM   #4
NGN
Registered User
 
NGN's Avatar
 
Join Date: Nov 2001
Location: Old Bridge,NJ
Posts: 838
Re: Where does this go?

I'm thinking also what jjzepplin has mention
NGN is offline   Reply With Quote
Old 12-22-2013, 12:32 PM   #5
Molberg
Registered User
 
Molberg's Avatar
 
Join Date: Dec 2012
Location: Manitoba
Posts: 644
Re: Where does this go?

Quote:
Originally Posted by jjzepplin View Post
There is a resistor inside the heater box that looks like a spring or something. I think it may go to that.
Yep... looks like the blower speed resistor connector.(top of air box behind the glove box area on mine
__________________
-Project Nitemare-

http://67-72chevytrucks.com/vboard/s...d.php?t=607359
Molberg is offline   Reply With Quote
Old 12-22-2013, 01:40 PM   #6
MusicMan70
Senior Member
 
MusicMan70's Avatar
 
Join Date: Feb 2011
Location: Corona, CA
Posts: 1,842
Re: Where does this go?

A location pic from my 70
Attached Images
  
__________________
MusicMan70
1961 GMC Suburban
MusicMan70 is offline   Reply With Quote
Old 12-22-2013, 04:12 PM   #7
terry b
Registered User
 
terry b's Avatar
 
Join Date: Oct 2011
Location: jackson michigan
Posts: 755
Re: Where does this go?

That is clearly not the same plug as in the first photo. The wires are also different colors.
terry b is offline   Reply With Quote
Old 12-22-2013, 04:19 PM   #8
Tuff Gong
Registered User
 
Tuff Gong's Avatar
 
Join Date: Jan 2011
Location: Glendale, AZ
Posts: 3,178
Re: Where does this go?

Fan switch?
Tuff Gong is offline   Reply With Quote
Old 12-23-2013, 12:36 PM   #9
48richard
Registered User
 
48richard's Avatar
 
Join Date: Oct 2009
Location: Phoenix, AZ
Posts: 475
Re: Where does this go?

From my 71 service manual, the connector with pink, green and orange is indeed the anti-dieseling relay. This keeps the A/C compressor clutch engaged for a few seconds after turning off the ignition, which loads the engine enough to stop it dieseling. If the A/C blower switch is on, you will also notice the blower run on for a few seconds.
__________________
1971 C10 Longbed, 350/TH350
48richard is offline   Reply With Quote
Old 01-21-2014, 07:12 PM   #10
BBrendal
Recalculating.....
 
BBrendal's Avatar
 
Join Date: Nov 2010
Location: New Lenox Il
Posts: 686
Re: Where does this go?

Quote:
Originally Posted by JimKshortstep4x4 View Post
The wiring connector is for the Anti-Dieseling Relay. If you don't have the solenoid on your carburetor with the connecting wiring you will not need it. The relay would normally be on the inside lower lip of the dash close to the controls.

Jim
Thanks Jim. That was the one. No need for me to connect.
__________________
Brian - (BBrendal)

1969 Chevy Camaro Z28
1972 Chevy Blazer CST
2004 GMC Yukon (The truck that pulls the car trailer)
1972 Chevy Blazer CST #2 (Finished and sold!)

Blazer build link...
http://s1213.photobucket.com/albums/...rendal/Blazer/
BBrendal is offline   Reply With Quote
Old 01-21-2014, 07:29 PM   #11
myyamr7
Registered User
 
myyamr7's Avatar
 
Join Date: Dec 2012
Location: Providence, RI
Posts: 211
Re: Where does this go?

Quote:
Originally Posted by BBrendal View Post
Thanks Jim. That was the one. No need for me to connect.

If you plan to hook up and use the AC, you will need that switch hooked up for the AC compressor to turn on. In the spring and fall around here, I reach under the dash and unplug mine so the compressor isn't on all the time
__________________
Mark
71 C10 Cheyenne
12 Aprilia RSV4
myyamr7 is offline   Reply With Quote
Old 01-21-2014, 07:56 PM   #12
BBrendal
Recalculating.....
 
BBrendal's Avatar
 
Join Date: Nov 2010
Location: New Lenox Il
Posts: 686
Re: Where does this go?

Quote:
Originally Posted by myyamr7 View Post
If you plan to hook up and use the AC, you will need that switch hooked up for the AC compressor to turn on. In the spring and fall around here, I reach under the dash and unplug mine so the compressor isn't on all the time
Hmmm! So where does that connect to? It is under my dash by my pass side but I cant find where to plug it in to.
__________________
Brian - (BBrendal)

1969 Chevy Camaro Z28
1972 Chevy Blazer CST
2004 GMC Yukon (The truck that pulls the car trailer)
1972 Chevy Blazer CST #2 (Finished and sold!)

Blazer build link...
http://s1213.photobucket.com/albums/...rendal/Blazer/
BBrendal is offline   Reply With Quote
Old 01-21-2014, 08:15 PM   #13
myyamr7
Registered User
 
myyamr7's Avatar
 
Join Date: Dec 2012
Location: Providence, RI
Posts: 211
Re: Where does this go?

On mine, the relay switch is bolted to the bottom of the dash between the glove box and the AC controls. I forgot the exact name of the switch, it looks similar to the fan relay switch.
__________________
Mark
71 C10 Cheyenne
12 Aprilia RSV4
myyamr7 is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 09:32 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com