KS Pre Valentines 2014 67-72 trucks parts SPECIAL

[karphan]

Interested in the gun rack in pictures 20. Shipped to Sparks, NV 89441. Thanks, Dan

[Brave71]

Randy, I need the V8 gas peddle set up , I can find a cable .. Let me know what total shipped to 89015 would be for peddle, fender brace ,and left and right grill brackets.. Thanks

[JimH2828]

Randy, no worries on the radio cups and nuts, I understand. Sounds like the hatch lifts are no good, thanks for the very honest response.

I hope the below list is not too much........about to start a Blazer restore project.


1) I meant, the radio 3 wire black connectors with green\black speaker wire....sorry for poor description
2) 3 Boots rings $25, I'll take them.
3) I would be interested in some Soft-Ray vent glass if you can come up with a good pair.
4) Vent screw and ferrules 6x $20, I'll take your cleanest.

new items:
5) Shift knob - any of those blank for Blazer 69-70 4x4?
6) Blazer gas tank fill pipes
7) Air cleaner nut, bottom one - post 17 pic 5
8) Blazer frame mounted shift linkage bracket - post 16 pic 2 ......have spring?
9) Coiled Oil pressure line - post 17 pic 2
10) Power steering dual line frame clip with nut - post 17 pic 5
11) Is that a Blazer fuel harness in post 6 pic 5? Cuts? connectors on both sides?
12) Is that Blazer rear side panel top chrome trim in post 5 pic 4? condition?
13) I saw some heat stove parts, any outer stove pieces?
14) 2 channel pulley - post 15 pic 2
15) Spark plug shields and retainers......complete set? Post 14 pic 2
16) Can you come up with a complete AC bracket set? post 14 pic 4
17) Are any of those transmission fill tubes and dip sticks for a TH350? post 4 pic 2
18) T-3 3 pong headlights - post 2 pic 5 and post 4 pic 4
19) Emergency brake pedal and bracket - post 2 pic 2
20) Med Blue glove box door hinge and screws - post 1 pic 2
21) Can you come up with a decent kick panel vent set? vents, pulls, vacuums, mount pieces.......I'm not even sure what is complete....I have a 70 Blazer CST with AC.
22) Any blazer carpet trim?
23) Any blazer tailgate seal trim? maybe in post 33 pic 3
24) Any ignition lock cylinders with stamp codes? post 27 pic 4
25) Is that a Blazer length main rear run wire harness? post 3 pic 5 cuts?
26) Any blazer seat parts?
27) any 4x4 pitman arms with bolt\nut?


Thanks
Jim

[magntik]

Randy,
I'll take the best looking AC/Heater control unit and one of the ac(?) doors that is in the outside cowl area.
Shipped to 52404

Thanks

[blackbolt]

Pic 69 is there and lower swb bed moldings?
Pic 84 orange a/c balls?
Any blazer hatch sliders?

[72swbcamo]

Are the Blue 4x4 hubs available?

[slowtruck]

I would like a price on an ac/heat control

And do you have any 67-68 side trim?

Shipping would be to 72023

[blackbolt]

Would you happen to have a set a straight dump exhaust manifolds? I'm wandering if those are the ones needed for a 4x4 k5

[teeitup]

jimer1964, I'll try to get quote Wed

karphan, Dan, $12 plus shipping

Brave71, I'll get pics and total Wed hopefully

JimH, I'll try to get everything laid out and pics Wed

magntik, I only have one with all good arms, but it has a replacement arm. It only slides half way across, not sure why $15 for it. On the outer Ac door, I think all may have a small chip or something small wrong with them. $5 for one. Plus shipping on all

blackbolt, no used swb trim, I only have one new basically NOS rear bed piece $20. Orange Ac balls $15. The hatch sliders I have are junk. All plus shipping

72swbcamo, sorry they are sold

slowtruck, I only have one decent AC control, your third on it. No 67-68 trim

Thanks Randy

[teeitup]

Blackbolt, sorry none of those

[blackbolt]

Which piece is it? Ill take the a/c balls for sure. Just send me a pm on where to send the cash. Shipping to 77505 please

[teeitup]

JimH, here is what I have off your list
greenblack wire with plug $5
radio wire $5
3 boot rings $25
softray wing windows pair $20
6 72 door scres $20
I have some blank shift knobs none of them
I only have the one short gas filler $20
air cleaner nut
frame bracket is for a BB-sold
coiled oil pressure line $10
no ps line clamps, those are AC clamps
no blazer fuel line harness
no blazer side panel holders
no heat shields
pulley $8
only partial set of plug heat shields
no full sets of AC brackets
tranny dipsticks I think are th350 $5 each
Two T-3 bulbs $20
ebrake pedal setup $10
glovebox door $10
kick panel vent I know I have pass side for AC and drivers $15
no blazer carpet trim
no blazer tailgate seal trim
no ign locks with stamp codes
blazer front to rear wiring harness $5
no blazer seat parts
no 4x4 pitman arms
I'll try to get pics of it all
Thanks Randy

[teeitup]

Blackbolt, I can't remember I will look and get pic
Thanks Randy

[blackbolt]

Ok thanks

[88JRFAN]

Hey Randy. Is that a high hump vinyl floor cover? If so, how much? Thanks, Daren

[Rusbuilt]

Randy I am looking for a good driver quality 69-72 green GMC steering wheel, any chance you have one? If so what the price shipped to 37210? Thanks

[tsmith]

Looking for some back glass chrome do you have any, if you do condition and shipped to 74857 Thanks

[Beaumont@]

I'll take the seatbelts. PM me your payment prefference and info.

[karphan]

Randy, I'll take the gun rack. PM sent for total and payment info. Thanks, Dan

[Ironangel]

Howdy Randy, I need a driver side black door panel for a 72... Looking for a set of unmolested 1/2 ton front coil springs...Need a driver side door handle too, got any of them? I'll come see ya and give some money I owe you... Thank you Randy

[teeitup]

Daren, sorry low hump

Rusbuilt, sorry no good steering wheels

tsmith, sorry I don't ship the rear window chrome

Beaumont@, it would be more to ship to Canada or do you have a USA address?

karphan, Dan, I will get you a total

IronAngel, Michael, no original black ones but I have these painted ones. No coils right now, just have a complete frontend. I'll have to look on door handles, I think I sold them all. I was going to pm you the other day but I thought we'd get through Christmas then get ahold of you

Thanks Randy

[Ironangel]

Right on Randy, sorry for the delay..I'll come see ya soon. Thanks.

[Beaumont@]

No sorry I do not have a U.S. address that's just the price we pay to live up here unfortunately. You can make it a little easier by sending it by USPS though. My postal code is:
T5T 6X4.
Thanks

[teeitup]

Michael, sounds good

Beaumont@, so $63 plus sipping, I will get a quote today for you

Thanks Randy

[70STOVEBOLT]

Randy I will take the BB linkage frame bracket and heater hose fender clamp for $18 shipped. I still have your paypal info, I will get you paid and pm shipping address.

Thanks
Mark