|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
12-23-2003, 12:47 AM
|
#1 |
|
Registered User
Join Date: Dec 2003
Posts: 3
|
Does a 208C2 transfer case interchange with a 208C3 ?
Does anyone know whether a 208C2 transfer case and a 208C3 will interchange. The C2 is from a Turbo 350 & I think the C3 is from a Turbo 400, both are 1985 & the same ratio. The problem is I do not have the C3 in hand so that I can compare them. Thank you wyoridgerunner
|
|
|
|
12-23-2003, 05:42 PM
|
#2 |
|
ROCKET POWER!
Join Date: Feb 2003
Location: Finland, Europe
Posts: 509
|
X-fer case input shafts might have different lenghts&spline counts, other than that since they're both 208C's they should interchange. Now since i've not had the opportunity to compare these two i cannot say for sure, however even if the input shafts differ you should be able to interchange them. Anyone have experience with this?
g'luck, -Axle
__________________
What did i do last nite? I had a wonderful time, That's what they tell me What did i do last nite? 1979 C-10 shortfleet: Olds 350, Th400, 12 bolt Current project: 1969 Olds 455 W-30, needing a rebuild |
|
|
|
|
12-23-2003, 08:55 PM
|
#3 |
|
Registered User
Join Date: Dec 2003
Posts: 3
|
Thanks for the reply. I will check it out. appreciate the info. Ridgerunner
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
