Truck drops 1,000 rpm's when put into gear(video) - Page 2 - The 1947 - Present Chevrolet & GMC Truck Message Board Network

KQQL IT · 03-05-2014, 08:40 PM

Needs a stall converter

Jake Wade · 03-05-2014, 08:53 PM

Too much cam, not enough converter, not enough CR for the cam ( that cam needs at least 10:1), valves out of adjustment( too tight), vacuum leak, initial timing too low, just a few things that come to mind.

Start with valve adjustment, no more than 1/2 turn past zero lash.

Best advice would be to swap that cam for something at least 10º smaller if this is a street driven truck.

03-05-2014, 08:40 PM	#26
KQQL IT At the body shop. Join Date: Aug 2009 Location: Land of fruits and nuts. Posts: 5,447	Re: Truck drops 1,000 rpm's when put into gear(video) Needs a stall converter __________________ " That didnt make it any newer " " Dont antique the equipment "

03-05-2014, 08:53 PM	#27
Jake Wade Registered User Join Date: Aug 2005 Location: Louisiana Posts: 711	Re: Truck drops 1,000 rpm's when put into gear(video) Too much cam, not enough converter, not enough CR for the cam ( that cam needs at least 10:1), valves out of adjustment( too tight), vacuum leak, initial timing too low, just a few things that come to mind. Start with valve adjustment, no more than 1/2 turn past zero lash. Best advice would be to swap that cam for something at least 10º smaller if this is a street driven truck.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.