|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-11-2014, 11:08 AM
|
#1 |
|
Registered User
Join Date: Jan 2013
Location: Nowata, OK
Posts: 29
|
Blazer Tank Install Question
So my blazer tank I found at a swap meet doesn't fit right between the frame rails by just cutting the spare tire bar. My question is: Is this the right tank? It looks like to make it work I would have to cut the rear most crossmember and possible shave the "crooked" crossmember to make it work. Even then it still might stick out past the frame rails an inch or two.
Any one else have any experience with this or any 2 cents of wisdom? |
|
|
|
04-11-2014, 02:02 PM
|
#2 |
|
Carpe manana
  
Join Date: Dec 2010
Location: Eau Claire, WI
Posts: 12,424
|
Re: Blazer Tank Install Question
Lots of posts about this install available by searching. Posting a pic of the tank would help. The frame crossmember is often notched out to increase ground clearance.
__________________
1972 K5 CST Highlander Blazer: http://67-72chevytrucks.com/vboard/s...d.php?t=708547 1972 K20 Cheyenne Super: http://67-72chevytrucks.com/vboard/s...d.php?t=528308  Members met: ORANGBLAZ, 2003 silverado, MikeCofield, BB72CHEVKT, Duncan&Son, Sameyrasmea72, THENEWMEXICAN, HotRod C/10, brianthelion02, Sport/Truck, ryanroo, michael bustamante, Dirt's72, Already Gone, WestButteTruck, 57taskforce, Moreyel, painterljp, AASmedic, SoCoC10, Lumaestas, carbuff382, Chevyland
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
