![]() |
![]() |
#1 |
Registered User
Join Date: Jun 2011
Location: Unionville CT
Posts: 168
|
Radiator shroud
Those of you who still use a mechanical fan and can't reuse the original fan shroud, what do you use? What diameter fan blades?
__________________
http://67-72chevytrucks.com/vboard/s...d.php?t=481531 |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: May 2004
Location: Eastern Oregon
Posts: 201
|
Re: Radiator shroud
|
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Jun 2006
Location: Idaho
Posts: 8,800
|
Re: Radiator shroud
When I dropped in the v8 I kept the radiator in the stock 6 location. I then went to the wrecking yard with some dimensions and grabbed one that was close (this was 1985). I had to fab some side mounts but it has served me well. Turned out it is a 69 Mustang V8 application, go good luck finding that today. Here is a pic to give you some inspiration. I just used the water pump fan spaced to get the blade centered in the venturi. It made a significant difference, without not much air get pulled thru the radiator by the fan.
__________________
1959 Chevy Short Fleetside w/ 74 4WD drive train (current project) OrrieG Build Thread 1964 Chevelle Malibu w/ 355-350TH (daily driver) Helpful AD and TF Manual Site Old Car Manual Project |
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Jan 2012
Location: Motown
Posts: 7,680
|
Re: Radiator shroud
what's not fitting? looks like it fits, if not your motor is in the wrong position.
with a grinder and a welder; nothing can't be modified to fit from your build
__________________
cool, an ogre smiley ![]() how to put your truck year and build thread into your signature shop air compressor timer |
![]() |
![]() |
![]() |
#5 |
Registered User
Join Date: Jun 2006
Location: Idaho
Posts: 8,800
|
Re: Radiator shroud
My fan is an aftermarket 18" diameter, non-clutch type. The inside of the shroud is 20". I'm with Orge, with a straight type shroud you should be able to adjust it up and down to center the fan, by redoing the bolt holes, same with side to side if the water pump is not centered on the radiator. Front to back should not be an issue since it is a cylinder and not venturi type. If it is too deep and interferes with the belts, tin snips and a edge rounding dolly will fix that. Mine has extensive modifications using tin and pop rivets to attach to the plastic shroud. Semi gloss plack paint hides pretty good.
__________________
1959 Chevy Short Fleetside w/ 74 4WD drive train (current project) OrrieG Build Thread 1964 Chevelle Malibu w/ 355-350TH (daily driver) Helpful AD and TF Manual Site Old Car Manual Project |
![]() |
![]() |
![]() |
Bookmarks |
|
|