|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-05-2014, 09:45 PM
|
#1 |
|
Registered User
Join Date: May 2008
Location: 204
Posts: 903
|
Upper control arm shaft and bolt question.
Are the bolts for the upper control arms supposed to be a loose fit? The bolt diameter is 1/2" and the holes in the shaft are about 9/16".
I am trying to figure out if it's supposed to be that loose for adjustment or if I ended up with 3/4 ton shafts when I bought replacements.
__________________
1969 Chevy Custom Camper 3/4 ton Rust free survivor 1972 Chevy Blazer CST 4x4 Almost Rust free survivor 1972 GMC Jimmy 2wd Undergoing surgery |
|
|
|
06-05-2014, 10:33 PM
|
#2 |
|
Registered User
Join Date: Feb 2012
Location: Mission Viejo, CA
Posts: 1,856
|
Re: Upper control arm shaft and bolt question.
i have a 3/4 ton and dont think there was that big a gap. but they are easy to slip on. not tight at all. the half moon washer and spacers hold it tight to the frame.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
