|
09-10-2014, 06:48 PM
|
#1 |
|
Registered User
Join Date: May 2014
Location: Granbury texas
Posts: 96
|
3 on the tree
Unusual problem. When I align the 3/16 pin in the slots and adjust the linkage it puts the column lever too far down and hits my leg. If I rest the pin on the column slot and push it through the actual lever holes then adjust the linkage the column lever is fine. Any comments? I did read the article that most folks point you too but it doesn't address this issue.
|
|
|
|
09-10-2014, 08:28 PM
|
#2 |
|
Registerd User
 
Join Date: Nov 2006
Location: Little Rock,AR
Posts: 220
|
Re: 3 on the tree
Loosen the brackets that hold the column and twist the whole column
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
