|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-03-2004, 05:22 PM
|
#1 |
|
Registered User
Join Date: Mar 2002
Location: Baton Rouge, Louisiana
Posts: 71
|
Master cylinder question
Anybody know what the type and size is of the master cylinder/brake line fittings ('72 1/2 ton w/power brakes)? I'm trying to round up/make some adaptors for bench bleeding. Thanks.
|
|
|
|
02-03-2004, 08:53 PM
|
#2 |
|
Account Suspended
Join Date: Mar 2003
Location: ** THE FALL GUY **CHICAGO IL
Posts: 5,883
|
MAN THAT SOUNDS LIKE TO MUCH TROUBLE.....
go to napa and buy a master cly. bleeding kit..... cost about 6.00.... then you can bleed any standard thread master cyl.... spend 12.00 and get the metric and standard set's now you can bleed any car or truck  just a thought..... the two fitting are different from the front to rear on a stock master,,,,hope this help's 
|
|
|
|
|
02-03-2004, 09:19 PM
|
#3 |
|
Registered User
Join Date: Mar 2002
Location: Baton Rouge, Louisiana
Posts: 71
|
ok, thanks. i haven't seen the cheap bleeding kits, but i'll look again. i think i want one of those 638 c.i. big blocks also.
|
|
|
|
|
02-03-2004, 09:22 PM
|
#4 | |
|
Account Suspended
Join Date: Mar 2003
Location: ** THE FALL GUY **CHICAGO IL
Posts: 5,883
|
Quote:
|
|
|
|
|
|
02-03-2004, 10:59 PM
|
#5 |
|
Registered User
Join Date: Nov 2003
Location: kc
Posts: 229
|
you can find them in the HELP section of most autoparts stores
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
