CA 1967 cab cuts,alot of good patch panels

[sawman]

part of the door frame/jam sold

[sawman]

ttt

[sawman]

ttt

[68is4me]

How about the pass inner lower cowl right below the vent

[68is4me]

Pics of what i need

[sawman]

you asking about inside right below passenger vent,its good down to the floor

[68is4me]

Yup,that water delector right below the vent opening were all the leaves and stuff sit

[sawman]

can you outline it so I no exact size you need,and what size in inches,,make offer shipped,thanks

[718jwh]

Need cut in picture 8" across back down to bottom, center of jamb down. Cost shipped to 60563
Thanks

[sawman]

718jwh can you outline in one of the pictures exact size area you want,thanks

[718jwh]

Need from the red line in the picture down to cab bottom about 8" across the back or center of first rib and middle of door jamb down your other pictures down show the back or jamb. If you need more info I can take a picture of mine
Thanks

[sawman]

ya if you could get a pic showing exact what size piece you want it would help,thanks

[718jwh]

Here is what I need

[sawman]

got it,you want it cut were you marhed about fuel necj hole down to bottom across back right below window to first line in back of cab,you do not want it cut all the way acoss back of cab,make me a offer shipped,will pm you,

[68is4me]

Would you so $35 shipped?

[68is4me]

Sawman, are you able to do that cut for me?

[sawman]

yes I can do that,

[cleanfreak]

Email sent , all good

[enduroride]

Sawman, can you cut me this section out of the upper passanger side cab corner ?

[sawman]

ttt

[sawman]

ye I can cut the roof corner out for you,

[Oddfire]

How much for this area above p/s door? I need it about 6" wide from the drip rail & to extend about 1-2" below the seam at the back like in the 2nd pic. My zip is 22630. Jamie71Longhorn

[Oddfire]

Oops: Enduro Ride beat me to it. Didn't see it till just now.

[sawman]

enduoride hasn't got back to me yet,

[sawman]

ttt