![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
![]() Join Date: Dec 2015
Location: Albuquerque
Posts: 773
|
Steering stabilizer mount
Does anyone know the measurement as to where the steering stabilizer bracket mounts on the tie rod of a 72 K20? I recently purchased the tie rod bracket and from an older thread I can see the approximate location but I was just wanting to know more exactly where it goes.
|
![]() |
![]() |
![]() |
#2 |
Registered User
![]() Join Date: Dec 2015
Location: Albuquerque
Posts: 773
|
Re: Steering stabilizer mount
Last edited by AASmedic; 02-01-2016 at 12:26 AM. Reason: did not capture photo |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Oct 2007
Location: Spanaway
Posts: 8,451
|
Re: Steering stabilizer mount
Just crank the wheel moving the tie rod towards the stabilizer, then collapse the stabilizer and pull it out about 1/4"and bolt it up.
Or if you want after doing the above just put a permanent marker mark on the tie rod, then turn the other way and pull the stabilizer to full extend and mark the tie rod again, you should be able to split the difference.
__________________
Mike. Swamp Rat build thread : http://67-72chevytrucks.com/vboard/s...d.php?t=595019 72 3/4T 4X4 4" BDS Lift 33" BFG's |
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Dec 2009
Location: El Dorado Ca
Posts: 3,374
|
Re: Steering stabilizer mount
do you still need a pic? or measurement?
|
![]() |
![]() |
![]() |
#5 |
Registered User
![]() Join Date: Dec 2015
Location: Albuquerque
Posts: 773
|
Re: Steering stabilizer mount
Yes sir. That would be great!
|
![]() |
![]() |
![]() |
#6 |
Registered User
Join Date: Dec 2009
Location: El Dorado Ca
Posts: 3,374
|
Re: Steering stabilizer mount
hope I can post a pic, the measurement is from the mount on the axle to the mount on the tie rod, I only have the stabilizer on my '74 axles, my '72 doesn't have a stabilizer.. the measurement from center of bolt to center of bolt is 18 3/4"
|
![]() |
![]() |
![]() |
#7 |
Registered User
Join Date: Dec 2009
Location: El Dorado Ca
Posts: 3,374
|
Re: Steering stabilizer mount
hope I can post a pic, the measurement is from the mount on the axle to the mount on the tie rod, I only have the stabilizer on my '74 axles, my '72 doesn't have a stabilizer.. the measurement from center of bolt to center of bolt is 18 3/4"
|
![]() |
![]() |
![]() |
Bookmarks |
|
|