![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
![]() Join Date: Mar 2014
Location: Orting, WA
Posts: 59
|
Help. Rag joint removal and replacement 72 blazer
I'm a little intimidated by this job but it desperately needs done. Any and all advice or a walk through on how to do it would be highly appreciated
|
![]() |
![]() |
![]() |
#2 |
Senior Member
![]() Join Date: Apr 2006
Location: Yuba City, Ca
Posts: 1,945
|
Re: Help. Rag joint removal and replacement 72 blazer
Are you looking to rebuild it or replace it? I rebuilt mine and it wasn't that bad. Replacing it is a piece of cake. One word of advice take the bolt that holds it to the box all the way off. It will hold the joint onto the shaft on the steering box even when it's loose. I couldn't see this because mine was in the truck. Be sure to get the right spline count as 4x4 is different than 2wd.
__________________
Kirk 72 Blazer CST 4wd highlander |
![]() |
![]() |
![]() |
#3 |
Registered User
![]() Join Date: Mar 2014
Location: Orting, WA
Posts: 59
|
Re: Help. Rag joint removal and replacement 72 blazer
Thanks, I'm gonna rebuild it. I bought the cheap 10 dollar help section kit at oriellys.
|
![]() |
![]() |
![]() |
#4 |
Senior Member
![]() Join Date: Apr 2006
Location: Yuba City, Ca
Posts: 1,945
|
Re: Help. Rag joint removal and replacement 72 blazer
Yea the rebuild wasn't too bad. I think I had to grind the rivets if I remember right. It turned out good and I just bolted it together with the hardware it came with. Tightened up the steering a lot.
__________________
Kirk 72 Blazer CST 4wd highlander |
![]() |
![]() |
![]() |
#5 |
Registered User
![]() Join Date: Mar 2014
Location: Orting, WA
Posts: 59
|
Re: Help. Rag joint removal and replacement 72 blazer
Thanks. Did you have to remove the shaft completely?
|
![]() |
![]() |
![]() |
#6 |
Senior Member
![]() Join Date: Apr 2006
Location: Yuba City, Ca
Posts: 1,945
|
Re: Help. Rag joint removal and replacement 72 blazer
You just unbolt the two bolts on the steering shaft from the joint and there is one bolt that clamps the joint to the shaft on the steering box. The shaft has some slide adjustment so you just move it out of the way.
__________________
Kirk 72 Blazer CST 4wd highlander Last edited by Blazerowner; 04-29-2016 at 11:42 AM. |
![]() |
![]() |
![]() |
#7 |
Registered User
![]() Join Date: Mar 2014
Location: Orting, WA
Posts: 59
|
Re: Help. Rag joint removal and replacement 72 blazer
Thank you for all the help. Much appreciated
|
![]() |
![]() |
![]() |
Bookmarks |
|
|