![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Dec 2013
Location: Marietta, OK
Posts: 277
|
Need opinions. 89 k30 in tank pump issues.
Recently got an 89 k30. It's originally a tbi 350 truck that has been converted to carb with an aftermarket pressure regulator/gauge feeding the carb. The truck has sat for 3 years without running.
I'm not getting fuel out of the pump. Is there a way to test the pump in the tank and bypass all the computer and old wiring? I unplugged the pumps two wire electrical plug and connected a good battery to the gray wire and to ground but it still did nothing. I'm thinking it could be a bad ground on the pump but I'm not sure without pulling the bed. Any insight or advice? Thanks The engine runs excellent if you keep the bowl full with a squirt bottle. |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Jun 2008
Location: Moss Point,Ms.
Posts: 1,439
|
Re: Need opinions. 89 k30 in tank pump issues.
Sometimes if the pump is stuck,you can try reversing the polarity.It may or may not work again.
Probably corrosion causing the problem. I recently had to pull the tank on a 89 G-30 van because the pump was running but not pumping.The short hose on the sending unit was blown out! These tanks are a pain to get out! Govt.corn gas again. Mike. ![]() |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Dec 2013
Location: Marietta, OK
Posts: 277
|
Re: Need opinions. 89 k30 in tank pump issues.
Thanks for the reply. Yeah I know these tanks can be a pain, that's why I'll go ahead and just pull the bed. Plus I wanna put on a straight bumper, better hitch, and tidy up the rear wiring harness.
I would think that hooking power to the pumps gray wire and grounding to a freshly ground spot on the frame would kick the pump on as long as the pump is grounded properly. Am I correct or am I missing something? |
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Dec 2013
Location: Marietta, OK
Posts: 277
|
Re: Need opinions. 89 k30 in tank pump issues.
Also I hear no noise at all from the pump. Like I'm doing nothing at all
|
![]() |
![]() |
![]() |
#5 | |
Moderator
![]() Join Date: Oct 2008
Location: Wentworth, NH
Posts: 4,951
|
Re: Need opinions. 89 k30 in tank pump issues.
Quote:
You are correct. It's just a Weatherpack connector to the sender and pump hot lead. I have a handful of both male and female Weatherpack and Metripack terminals to in my test lead box so I can run tests without damaging the connectors.
__________________
1959 M35A2 LDT465-1D SOLD 1967 Dodge W200 B383, NP420/NP201 SOLD 1969 Dodge Polara 500 B383, A833 SOLD 1972 Ford F250 FE390, NP435/NP205 SOLD 1976 Chevy K20, 6.5L, NV4500/NP208 SOLD 1986 M1008 CUCV SOLD 2000 GMC C2500, TD6.5L, NV4500 2005 Chevy Silverado LS 2500HD 6.0L 4L80E/NP263 2009 Impala SS LS4 V8 RTFM... GM Parts Books, GM Schematics, GM service manuals, and GM training materials...
And please let us know if and how your repairs were successful. |
|
![]() |
![]() |
![]() |
#6 |
Registered User
Join Date: Dec 2013
Location: Marietta, OK
Posts: 277
|
Re: Need opinions. 89 k30 in tank pump issues.
Well, finally got the bed off and found the issue. The pump is toast and the tank is filled with rust. Just ordered a new tank/pump kit from rock auto. $200 bucks including shipping with new straps and lock ring kit. Hopefully this'll make it driveable!
|
![]() |
![]() |
![]() |
Bookmarks |
|
|