![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Jul 2001
Location: Gilbert, AZ
Posts: 48
|
![]()
Does anyone have any pictures or information on how to remove drip rails..so far i have removed the spot welds from the underside without breaking through...and have successfuly removed the biggest piece of the drip rail on the doors....from the a pillars to the front of the cab is a different story...it looks a bit more involved so i haven't done anything to that yet......i need info or pics asap......
Thank You Cesar Mata
__________________
1969 Chevy Longbed |
![]() |
![]() |
![]() |
#2 |
It's a catastrophic success.
![]() Join Date: Jan 2003
Location: Oklahoma
Posts: 2,077
|
This has been asked before so you might try "search"
but the advice that I have heard was to cut a small amount off then weld it up then cut some more taking it slow. There are three pieces that come together at this seam. |
![]() |
![]() |
![]() |
#3 |
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
you shouldn't be cutting sections out that are more than 6inches long!!!!!
with a cutoff wheel cut out a 3-6 inch section then weld it up go to the other side of the cab and do the same section , repeat this sequence about 50times then grind the welds and putty it smooth and yer ready fer paint
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
![]() |
![]() |
![]() |
Bookmarks |
|
|