![]() |
![]() |
#1 |
Registered User
Join Date: Jul 2017
Location: Joshua, Texas.
Posts: 1,303
|
Tilt steering column
Can anyone point me towards a good how to video on replacing turn signal switch in a tilt column? I've done non tilt and want to make sure I see how it comes apart. My switch is cracked, and I just got a new switch in.
Thanks guys!
__________________
1950 Build |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Feb 2010
Location: rochelle il.
Posts: 356
|
Re: Tilt steering column
I have just disassembled a tilt column to sand blast and paint. I took a lot of pics on my phone but I can't pull them up. I looked on you tube several on there. Unless your going to take the whole column apart. You will probably going to have to take the wires out of the connector. I just used a small cotter pin to get the wires out of the connector. Wrap a string or lite wire around the switch wires and pull it through. You will have to do the same to the new switch and pull back through. Sorry I couldn't get pics up but new phone and me are not getting along.
|
![]() |
![]() |
![]() |
#3 |
Old member
Join Date: Jan 2002
Location: Liberty, & Garden City S.C. , U.S.
Posts: 19,936
|
![]()
I did this a few months ago on my tilt. I took the pins out tied string to the wires pulled it out then just pulled it back through. the upper signal part is a little tricky to get in but it goes in pretty easy. Just take your time. It looks like it want fit with the E flasher nub but it does.
![]()
__________________
1971 LWB Custom, 6.0LS & 4L80E, Speedhut.com GPS speedometer & gauges with A/C. 20" Boss 338's Grey wheels 4 wheel disc brakes. My Driver Seeing the USA in a 71 ![]() Upstate SC GM Truck Club 2013,14 and 2016 Hot Rod Pour Tour http://upstategmtrucks.com/ Get out and drive the truck this summer and have some fun! It sucks not being able to hear! LWB trucks rule, if you don't think so measure your SWB! After talking to tech support at Air Lift I have found out that the kit I need is 60811. Per the measurements I gave them. Ride height of truck inside spring and inside diameter of springs. |
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Oct 2008
Location: Marianna Arkansas
Posts: 7,269
|
Re: Tilt steering column
The upper shroud is no problem to pull off. Run a super small flat blade screwdriver around the joint and keep going around about 10 times or so and pull upwards on that shroud from the top and after just a little bit of time it will pop off gaining you much access.Have fun !! Jim
|
![]() |
![]() |
![]() |
Bookmarks |
|
|