|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-05-2019, 12:09 AM
|
#1 |
|
Registered User
Join Date: Feb 2016
Location: Columbia TN
Posts: 145
|
Ball stud/z bar bushing?
What goes here to make it nice and tight? Frame side is tight. Block side is sloppy
Posted via Mobile Device |
|
|
|
03-05-2019, 12:14 AM
|
#2 |
|
Registered User
Join Date: Feb 2016
Location: Columbia TN
Posts: 145
|
I assume this. But don’t see how that won’t just push in the z bar
Posted via Mobile Device |
|
|
|
|
03-05-2019, 08:34 AM
|
#3 |
|
Registered User
Join Date: Feb 2016
Location: Trenton,Ontario & South Carolina
Posts: 755
|
Re: Ball stud/z bar bushing?
There is a step inside the Z bar,or should be, just press in and it will bottom out.
|
|
|
|
|
03-05-2019, 09:15 AM
|
#4 |
|
Registered User
Join Date: Jun 2002
Location: Tucson AZ by way of WI & CA
Posts: 509
|
Re: Ball stud/z bar bushing?
Check out this thread. When I did mine I laid out the parts to make sure I had it right.
http://67-72chevytrucks.com/vboard/s...d.php?t=372974 |
|
|
|
|
03-05-2019, 10:25 AM
|
#5 | |
|
Registered User
Join Date: Feb 2016
Location: Columbia TN
Posts: 145
|
Quote:
Thanks. The more i looked at mine. It definitely seems like I need something in the groves of the ball. Posted via Mobile Device |
|
|
|
|
|
03-07-2019, 12:39 AM
|
#6 |
|
Registered User
Join Date: Feb 2016
Location: Columbia TN
Posts: 145
|
The more I’ve read. Seems two plastic seats go on either side of the frame side ball. But, the block side ball doesn’t get a seat? I understand it has to be able to move being on the block but just seems like it moves a lot. With this design maybe the block side ball is just worn small?
Posted via Mobile Device |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
