![]() |
![]() |
#1 |
Registered User
Join Date: Jan 2002
Location: Canton, Georgia, USA
Posts: 1,119
|
Got carb, now what?
I'm installing a carter carburator (Just like edelbrock) I got from board member 70c10 (Great guy to deal with btw) and I've just got a few questions. My old Holly was manual choke so I know I've got to run a wire from fuseblock to choke that is hot with key, but what guage wire and do I need to put an inline fuse with it. Also, what about linkage connection. My throttle cable, and detent cable, and springs don't look to smooth so far. Any suggestions?
Thanks, Jeremy.
__________________
Jeremy (NUBOMB) 72K5 CST 350/350/205 1951 Chevy 1/2 ton North Georgia Group "... And the first rule to being a man is you gotta spend your life doing crap you don't wanna do." Red Forman. |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Nov 2003
Location: Alexandria, VA
Posts: 1,534
|
Use 16 ga. red wire from a switched source on the fuse block. I think a 5A inline fuse would be alright for this application.
__________________
'72 GMC SWB C1500 Custom, frame-off in progress. 383 SBC, 9:1CR, Comp Cams XE262H, Scat internal balanced crank, Eagle SIR 6" rods, Keith Black dish pistons, Dart Iron Eagle 72/180 heads, Weiand Stealth intake, Stewart stage I water pump, Holley 4bbl vac sec, TH350 with B&M Shift Improver Kit. 12 bolt positraction. ![]() ![]() ![]() |
![]() |
![]() |
![]() |
#3 |
Account Suspended
Join Date: Dec 2003
Location: Texas
Posts: 2,686
|
The linkage is in the same spot as a holley i switched back and forth a few times back in the day the only swap that ran into any probs was q-jet to edelbrock or holley .
|
![]() |
![]() |
![]() |
#4 |
67-72 Addict!
Join Date: Feb 2002
Location: The TAX State!
Posts: 7,857
|
Wow Jeremy, that got there faster than I thought!. As far as the linkage goes, my truck has the rod style linkage and I had no problems going from that carb to the Demon. There should be lots of pics on here with guys running Edelbrock's with the cable setup like yours. Also for the manual that you can print out go here: www.edelbrock.com and look for the square bore EPS manual. Keep us posted!
![]()
__________________
Jim 1970 C/10 Fleetside w/Ghost Flames Lowered 4.5" front and 4" rear (Raked) 355/350 Turbo w/shift kit 10" Redneck Performance Verter w/2500 stall Hooker Super Comps part#2808-1 Performer RPM Air-Gap 12 Bolt w/3:73 gears- Eaton Posi Comp Cams XE262 with 1.6 Crane Energizers, Road Demon 625 and Brodix IK 180 heads |
![]() |
![]() |
![]() |
#5 |
Registered User
![]() Join Date: Sep 2001
Location: Cumming, GA
Posts: 471
|
Another Georgian! I'm not much help on this one, but nice to see GA members.
|
![]() |
![]() |
![]() |
Bookmarks |
|
|