Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
04-08-2019, 09:46 PM | #1 |
Registered User
Join Date: Jun 2018
Location: Ventura, Ca
Posts: 206
|
67 V8 drivers side exhaust manifold
Drivers side exhaust manifold from my 67. I cleaned it up in the blast cabinet and it cleaned up good with just a few rust pits and no cracks. It has started a little surface rust since then but I will clean it again before it is shipped. The studs are ok but would likely need replacing if you don't use the original flapper valve piece since the studs are really long. Casting number is 3855163A with LH10 just below that. SOLD!
__________________
Last edited by morepwr; 04-09-2019 at 06:36 PM. |
04-08-2019, 09:49 PM | #2 |
Senior Member
Join Date: Dec 2009
Location: TN.
Posts: 8,409
|
Re: 67 V8 drivers side exhaust manifold
I will take it.
__________________
________________________________________________________________________________________ ____________________________________________ 84 Chevy K-20 63 Impala (my high school car) http://67-72chevytrucks.com/vboard/s...Crew Cab Build |
04-08-2019, 11:10 PM | #3 |
Registered User
Join Date: Jun 2018
Location: Ventura, Ca
Posts: 206
|
Re: 67 V8 drivers side exhaust manifold
__________________
|
04-09-2019, 05:50 PM | #4 |
Senior Member
Join Date: Dec 2009
Location: TN.
Posts: 8,409
|
Re: 67 V8 drivers side exhaust manifold
Money sent.
Thanks .
__________________
________________________________________________________________________________________ ____________________________________________ 84 Chevy K-20 63 Impala (my high school car) http://67-72chevytrucks.com/vboard/s...Crew Cab Build |
Bookmarks |
|
|