|
10-05-2019, 02:29 PM
|
#1 |
|
Registered User
Join Date: Aug 2015
Location: Texas
Posts: 328
|
Replace pcv grommet
Is there an easy way to replace the pcv grommet without removing valve covers?
|
|
|
|
10-05-2019, 02:32 PM
|
#2 |
|
Senior Member
 Join Date: Mar 2003
Location: Colfax-California
Posts: 8,667
|
Re: Replace pcv grommet
small flat blade screwdriver down the side of the grommet and pry it out. Unless it is hard as a rock and cracked, then it will come out in pieces. After that you can pull pieces out of the hole with some needle nose pliers
|
|
|
|
|
10-05-2019, 02:40 PM
|
#3 |
|
Registered User
Join Date: Aug 2015
Location: Texas
Posts: 328
|
Re: Replace pcv grommet
How to put new one in?
|
|
|
|
|
10-05-2019, 03:43 PM
|
#4 |
|
Registered User
Join Date: Aug 2009
Location: Bowser
Posts: 13,750
|
Re: Replace pcv grommet
Lube it liberally and rotate it in to place.
I use wd40 for a lube. Some stubborn ones I’ve had to cut a small notch in the bottom lip for a starter point. |
|
|
|
10-05-2019, 04:58 PM
|
#5 |
|
Senior Member
Join Date: Mar 2003
Location: Colfax-California
Posts: 8,667
|
Re: Replace pcv grommet
You don't have to cut anything, the new one will be pliable enough to twist and wiggle in
|
|
|
|
|
10-05-2019, 08:41 PM
|
#6 |
|
Registered User
Join Date: Oct 2016
Location: Dallas Texas
Posts: 3,243
|
Re: Replace pcv grommet
.
You can also put the grommet on your pcv valve or vent and use that as an install "tool" to get it in there. Careful you don't break the tool though. -klb
__________________
67 C10 fleet fuel injected '70 402, 700r4, 3.73 posi 07 335 sport turbo 6sp 94 Trans Am GT LT1 6sp posi -- sold after 22yrs 99 540 sport V8 6sp -- sold 73 240z L24 4sp -- given to friend 68 C10 step 350/350 3.73 open -- sold |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
