|
12-01-2019, 05:19 PM
|
#1 |
|
Registered User
Join Date: Jul 2008
Location: Eastern Oregon
Posts: 2,383
|
Brake Light Reset ?
Can you guys explain how to get the brake warning light to turn off. I was told it comes on if the pressure in the two separate lines are not equal. I see no leaks and both sides of master are full...thanks
__________________
71 C-20 07 Magnum RT AWD |
|
|
|
12-01-2019, 05:36 PM
|
#2 |
|
Moderator
 
Join Date: Jun 2017
Location: Cherryville, NC
Posts: 2,204
|
Re: Brake Light Reset ?
Remove the wire from the switch in the distribution block
Remove switch from the distribution block Pump the brake pedal hard a couple of times Replace the switch and the wire... The light should now be off The switch trips over and locks out the brake circuit that has a pressure loss....check for brake fluid leaks around hoses, wheel cylinders and calipers etc Hope this helps 
__________________
Family and country before all others... 2006 Chevy Silverado (Daily Driver) 2012 Chevy Equinox 
|
|
|
|
|
12-01-2019, 05:39 PM
|
#3 |
|
Registered User
Join Date: Jul 2008
Location: Eastern Oregon
Posts: 2,383
|
Re: Brake Light Reset ?
Thanks can you explain how to remove the switch ? Does it just unscrew ?
__________________
71 C-20 07 Magnum RT AWD |
|
|
|
|
12-01-2019, 05:45 PM
|
#4 |
|
Moderator
Join Date: Jun 2017
Location: Cherryville, NC
Posts: 2,204
|
Re: Brake Light Reset ?
Remove the wire, it just pulls off
The switch just unscrews...use a box wrench...I think it is 9/16 or 5/8....you may even here the valve click back to center.... Pump the brakes a few times, then reinstall the switch and wire
__________________
Family and country before all others... 2006 Chevy Silverado (Daily Driver) 2012 Chevy Equinox
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
