|
02-19-2023, 10:56 PM
|
#1 |
|
Registered User
Join Date: Feb 2007
Location: Ottawa, ON, Canada
Posts: 29
|
Cab floor height
So I'm replacing the entire floor in my 67 and the more I dig into it the more I find that the rear of the cab has been hacked. I'm finding that I can't trust what's left of the cab in the rear and I was hoping that someone could measure the distance from the floor to the seam at the fuel tank mount (as shown below).
 Thank you.
__________________
Kevin C. 1967 GMC 920 dually https://67-72chevytrucks.com/vboard/...46#post9179146 1975 Toyota Land Cruiser FJ40 https://forum.ih8mud.com/threads/my-...thread.182303/ |
|
|
|
02-20-2023, 09:41 AM
|
#2 |
|
Junior Member
 Join Date: Feb 2022
Location: Ohio
Posts: 78
|
Re: Cab floor height
I just replaced the floor in my '67, the measurement you show is 18 1/4". I was able to leave the angle supports spot welded to to back panel in place to use for location, after the floor was welded in I replaced them as they were getting rusty also.
|
|
|
|
|
02-20-2023, 02:36 PM
|
#3 |
|
Registered User
Join Date: Feb 2007
Location: Ottawa, ON, Canada
Posts: 29
|
Re: Cab floor height
Thank you for the info 67km1590
__________________
Kevin C. 1967 GMC 920 dually https://67-72chevytrucks.com/vboard/...46#post9179146 1975 Toyota Land Cruiser FJ40 https://forum.ih8mud.com/threads/my-...thread.182303/ |
|
|
|
|
02-24-2023, 11:43 AM
|
#4 |
|
Senior Member
Join Date: Oct 2020
Location: Kathleen, GA
Posts: 651
|
Re: Cab floor height
Out of curiosity I measured mine as well, it is 18 1/4 as 67km1590 previously stated.
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
