|
01-21-2025, 12:01 PM
|
#201 |
|
Registered User
Join Date: Nov 2015
Location: portage wi
Posts: 511
|
Re: project 39
a couple of more pics of what i have been working on. the small pieces are the fender bottoms that i made. the tubing is for the hammer form for the roll pan that i decided to make because i didnt like like the first one. i bent the tubing on the new bender we have downtown that i bought square tube dies for. it is awesome to be able to bend 1" square and i plan on buying more square sizes as i go. i thought i had a finish pic of the pan but i dont. will get one and post it. if you are wondering about the wrinkles from shrinking the bottom section of fenders i left them that way because no one will see them anyway and they seem to be stronger than if i hammered them flat. i figure if i do both sides the same it will look intentional. the shrinking was done on a tool that i built after watching a youtube video. the tool is a lot faster way of shrinking 18 gauge than the shrinker that i had bought.
|
|
|
|
07-18-2025, 03:25 PM
|
#202 |
|
Registered User
Join Date: Nov 2015
Location: portage wi
Posts: 511
|
Re: project 39
havent forgot about you guys following this build. i have been working on project 39 but everytime i load my pics on to my computor i cant find them to post on here. dont know what is going on.
|
|
|
|
|
07-18-2025, 03:37 PM
|
#203 |
|
Senior Member
  
Join Date: Oct 2014
Location: Eagle, ID
Posts: 3,406
|
Re: project 39
Well, let's get that squared away!!!
|
|
|
|
|
11-24-2025, 03:57 PM
|
#204 |
|
Registered User
Join Date: Nov 2015
Location: portage wi
Posts: 511
|
Re: project 39
i know its been a while but i have been fighting with the computor to find my pics. So if you look back at the last page i had cut off the door skin on the drivers door because i was not happy with the way it was going. i made a new skin but wasnt happy with the first attempt. this is the second attempt and i think it looks pretty good. i also decided to work on the interior panel as well. i am happy enough with the outcome. it can always be better but i always learn as i go. i was happy with this side so on saturday i pulled the door off the passenger side and cut that skin off as well. so here i go again. the nice thing about6 removing the outer panel is the access to the structure inside. i cleaned everything as well as i could and epoxy primed it before putting the skin on. when i am done i will spray lizard skin on the inside for sound and heat control.
|
|
|
|
|
11-25-2025, 10:08 AM
|
#205 |
|
Senior Member
Join Date: Oct 2014
Location: Eagle, ID
Posts: 3,406
|
Re: project 39
Looks really good. Well done
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
