|
06-25-2025, 12:01 AM
|
#1 |
|
Registered User
Join Date: Aug 2008
Location: greensboro nc
Posts: 895
|
4l80e in 69 Panel
I have a good 4l80e transmission for trucvk I bought mainly to snag tansmission. Sold truck engine and few parts for way more than truck cost. Figured toi install in69 panel. Add a controller to make it work when istalling EFi later on and use cheap manulat shift conversion pice for while.
While yes can pull old three on tree and test fit to see it will clear floor and build rar mount for it. Lazy and looking for info on fit and it will require cutting floor so can have material on hand and [retty much ready .Just cut floor to fit and bend up new tunnel,weld in and make look factory. No problems.LMAO Will it fit or will I be cutting truck up.
__________________
Only the stupid know too much to learn something new. |
|
|
|
06-26-2025, 05:12 PM
|
#2 |
|
Registered User
Join Date: Oct 2012
Location: VENTURA COUNTY CALIFORNIA
Posts: 333
|
Re: 4l80e in 69 Panel
Sorry but I don’t have an answer for you on this. Might get a few more eyes on it in the truck side though. May want to ask over there unless someone chimes in.
|
|
|
|
|
06-26-2025, 07:39 PM
|
#3 |
|
Registered User
Join Date: Aug 2008
Location: greensboro nc
Posts: 895
|
Re: 4l80e in 69 Panel
good idea nobody showing any interest in here.
__________________
Only the stupid know too much to learn something new. |
|
|
|
|
06-27-2025, 04:36 AM
|
#4 |
|
Registered User
Join Date: Oct 2012
Location: VENTURA COUNTY CALIFORNIA
Posts: 333
|
Re: 4l80e in 69 Panel
There’s just way more folks in the truck side, we get a bit forgotten over here😂
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
