Hole locations for trim pieces:

[Extended Power]

Good morning,
I scored a beautiful set of “Custom Camper” emblems and would like to just use the “Custom” part of them but...I need to know where to drill the holes on each side.
Would anyone have a set of doors that could measure distances from “here to here” to locate these properly for me?

Also, I have the tailgate trim I am installing but only need to drill the holes for the grab handle. I am using 3M for the rest of it.
What are the size of holes, and exact location for the two holes for the center piece?
Thank you so much!

In the picture below that I found...can someone confirm that from dead center of the tailgate, measure from the center, out 3.37” each way, and Mark for the holes?

[Extended Power]

Had a fella respond to me on FB.
He measured from the top of the tailgate down, and said the holes were 7 5/8” from the top of the tailgate.
If anyone cares to know.