Does anyone make replacement toe boards for 1964-65-66?

[cgrocen]

Hello, does anyone make replacement toeboards for 1964-65-66 Chevy trucks? I have a 1965 C30 in need of some replacement sheet metal for both sides, mostly at the outermost edges. See photos. Thanks!

[1964FarmFreshC10]

yes a simple google search came up with many suppliers

[cgrocen]

Hello 1964FarmFreshC10, I have seen bead rolled custom toe boards with a Google search. That is not what I am after. I am looking for die stamped toe boards that are the same as the factory toe boards with the correct ribs and depression for mounting the dimmer switch. A Google search does not show any of the die stamped toe boards that I am looking for. Regards, Chris

[cwcarpenter98]

https://www.classicindustries.com/pr...ts/153896.html

This may be more of what you’re looking for?

Also found this: https://classicparts.com/1964-66-fro...a-pillar-right


And if you don’t have them already, there’s replacement floor pans that go up to the firewall lip. You can also get a completely new floor from front to back, side to side. May be a good option for you if the rear sections of your floor are heavily damaged also

[cgrocen]

Hello cwcarpenter98, I do not need the whole firewall, I am looking for just the areas that I highlighted in my photos, for what I call toe boards. I have seen the second part that you suggested, but I believe that I do not need that one. I do have the replacement panel for the inside lower part of the pillar area. I am mostly concerned about the area where the dimmer switch mounts as it is recessed. Regards, Chris

[cwcarpenter98]

From what I was seeing on the different parts places, I wasn’t seeing just a smaller section of that firewall panel. That firewall panel would have the sections you need for both sides if you choose to go that route.

[cgrocen]

Hello cwcarpenter98, That is an option. Thanks, Chris