To Cut or Not to Cut - The 1947 - Present Chevrolet & GMC Truck Message Board Network

wxman1 · 01-23-2005, 09:00 AM

I've got a new Painless wining harness for my 69 C10 pickup.
When I got this truck about 2 1/2 yrs ago, I installed a custom dash.
I've machined a new aluminum plate dash and I'm getting it fixed up
to replaced the wooden one.

When I originally put in the custom wooden dash in I cut the old (original)
dash harness connector off. Well, I'd like to NOT do that to the new
Painless harness (pictured below). Anybody got any suggestions?

Jim
Mt Juliet
655 am with 15F - a skiff of snow on the ground

01-23-2005, 09:00 AM	#1
wxman1 Senior Member Join Date: May 2002 Location: mt juliet, tennessee, usa Posts: 237	To Cut or Not to Cut I've got a new Painless wining harness for my 69 C10 pickup. When I got this truck about 2 1/2 yrs ago, I installed a custom dash. I've machined a new aluminum plate dash and I'm getting it fixed up to replaced the wooden one. When I originally put in the custom wooden dash in I cut the old (original) dash harness connector off. Well, I'd like to NOT do that to the new Painless harness (pictured below). Anybody got any suggestions? Jim Mt Juliet 655 am with 15F - a skiff of snow on the ground

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.