![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Senior Member
![]() Join Date: Sep 2001
Location: Seattle, WA, USA
Posts: 5,817
|
Pulling distributor....I got an idea.
I got everyting ready to swap manifolds. I was thinking yesterday about the distributor, and how to pull it and replace it without loosing my timing. In other words I want the distributor to go back in in EXACTLY the same place it was when I pulled it. Since I haven't done this before EVER I started brainstorming.
Why not take a straight edge, and lay it across the distributor in between the terminals (mark the terminals of course) so that it points to a spot on the firewall, and then just make a mark on the firewall with some white wax pencil or something? That way when I put the distributor back in I just put the straight-edge back where it was and move the distributor until it lines up with the mark?!? Good idea? I think so. If not please correct my fuzzy math.
__________________
'69 3/4 ton C20 2wd-350ci/TH400 '69 3/4 ton Custom 20 2wd-350ci/4sp Manual '99 2wd 5.7 Chevy Tahoe Seattle, WA. |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|