redone sbc heads....

[wannabeburbowner]

I have a set of 882 casting 1.94/1.5 76cc sbc heads that I need to sell $100. All redone last fall, have less than 500 miles on them. New stock valve springs, shaved .015-.020. have a little surface rust on them from sitting for about a month. The only reason I pulled them is because I spun a bearing in the motor and just swaped out a complete motor. I just don't have need for them and need the money. It would be great to find a local buyer, shipping is on the buyer though. i could deliver for the cost of gas. PM me if interested. I also have a edelbrock torker intake. Pretty clean, but a couple of the square bore holes are stripped at the top. Could either use longer bolt or put heli-coil in it. $35 + shipping

Thanks,

Travis