dana 44 wheel bearing nut spanner socket? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

robertwb · 05-05-2005, 06:05 PM

I'm trying to get the hub/rotor off to replace the ball joints-I have the 4 prong tool that gets the lock nut off and right behind that is a round nut with holes around it-looks like there is probably another tool that removes this nut-I tried the punch and hammer and it wouldn't budge and I don't want to screw it up

can someone confirm that there is a special tool for this and where to get one? everywhere in town here says the 4 prong one is the only tool...obviously there's more

robert

05-05-2005, 06:05 PM	#1
robertwb Registered User Join Date: May 2003 Location: brooksville-fla Posts: 77	dana 44 wheel bearing nut spanner socket? I'm trying to get the hub/rotor off to replace the ball joints-I have the 4 prong tool that gets the lock nut off and right behind that is a round nut with holes around it-looks like there is probably another tool that removes this nut-I tried the punch and hammer and it wouldn't budge and I don't want to screw it up can someone confirm that there is a special tool for this and where to get one? everywhere in town here says the 4 prong one is the only tool...obviously there's more robert __________________ 1972 LWB 4x4 1970 LWB 2wd 1971 chevelle 1972 datsun PL-521/nissan

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.