Just cut my springs and I'm not feeling confident about it! - The 1947 - Present Chevrolet & GMC Truck Message Board Network

5150 · 05-07-2005, 06:54 PM

Hey guys,

I asked this a while back and finally decided to get a blade to my skil saw today. These are the factory springs that I sold with my yellow 69. Th PO said I could have them. I can't be sure that the ones on my truck now have been tampered with.

Well, I cut one coil off from the bottom (the fat end) and it just didn't seem like that much. I thought maybe some guys here had some measurements on a 2 inch drop spring I could compare to. That is the drop I'm after, because I have drop spindles also.

Thanks,

Bryan

05-07-2005, 06:54 PM	#1
5150 C10 Club Tennessee Join Date: Mar 2003 Location: White House, TN 37188 Posts: 8,281	Just cut my springs and I'm not feeling confident about it! Hey guys, I asked this a while back and finally decided to get a blade to my skil saw today. These are the factory springs that I sold with my yellow 69. Th PO said I could have them. I can't be sure that the ones on my truck now have been tampered with. Well, I cut one coil off from the bottom (the fat end) and it just didn't seem like that much. I thought maybe some guys here had some measurements on a 2 inch drop spring I could compare to. That is the drop I'm after, because I have drop spindles also. Thanks, Bryan __________________ Bryan www.gmtruckshow.com Project "Andes"-Halen's First Truck Project: Patina Burb for he is God’s servant for your good. But if you do wrong, be afraid, for he does not bear the sword in vain. For he is the servant of God, an avenger who carries out God’s wrath on the wrongdoer. Romans 13:4

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.