|
06-14-2005, 02:14 PM
|
#1 |
|
Life is a gamble
Join Date: Oct 2003
Location: Lee's Summit, MO
Posts: 796
|
Rivet removal
I'm trying to install a sway bar, but to do that, I have to remove two rivets. I've started on the first. Its on the driver's side. I have ground off the top of it with a grinder. I've been using a punch and hammer to push the rivet through. So far I've only moved it about a 1/16th. I've sprayed it with PB Blaster several times. Any suggestions?
I know that many of you on the board have done this mod. I figure someone can give me some advice. Thanks
__________________
1970 Orange CST C-10 w/350, posi, Longbed The torpid artist seeks inspiration at any cost, by virtue or by vice, by friend or by fiend, by prayer or by wine. -- Ralph Waldo Emerson |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode