1972 grill alignment - The 1947 - Present Chevrolet & GMC Truck Message Board Network

gefs55 · 06-22-2005, 11:58 PM

Was wondering if any of you have run into this problem. Have a 1972 c-10 have a new right fender, right inner well, radiator support and inner and outer grill. After replacing them the headlight is to low on the driver's side to let the headlight bezel go in. Passenger side fits fine. I have adjusted everything I can think of, including the height of the radiator support. Everything matches to the height of the frame. It appears the only damage to this truck when I bought it was to the passenger fender the rest was replaced because of age and rust. Any suggestions???

06-22-2005, 11:58 PM	#1
gefs55 Registered User Join Date: Nov 2004 Location: Lebanon ohio Posts: 22	1972 grill alignment Was wondering if any of you have run into this problem. Have a 1972 c-10 have a new right fender, right inner well, radiator support and inner and outer grill. After replacing them the headlight is to low on the driver's side to let the headlight bezel go in. Passenger side fits fine. I have adjusted everything I can think of, including the height of the radiator support. Everything matches to the height of the frame. It appears the only damage to this truck when I bought it was to the passenger fender the rest was replaced because of age and rust. Any suggestions???

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.