Rocker box question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

69stepside4x4 · 07-01-2005, 04:24 PM

I have a silly question but I thought someone could help me easy my mind about an impending project.

Are the rocker boxes a direct "bolt-in" or is there welding needed to replace them? I've been living in London of the past year and a half and just got home two weeks ago. First Saturday I was home I pulled the K5 out of storage, fired it up and sent it to the shop for a new tranny rebuild. I'm suppose to pick it up after work today and hope to get to work on the body over the long weekend.

Thanks for your knowledge and it's good to be back home in the land of the free!

Mac

'72 CST Blazer

07-01-2005, 04:24 PM	#1
69stepside4x4 Registered User Join Date: Mar 2005 Location: Atlanta, Georgia Posts: 32	Rocker box question I have a silly question but I thought someone could help me easy my mind about an impending project. Are the rocker boxes a direct "bolt-in" or is there welding needed to replace them? I've been living in London of the past year and a half and just got home two weeks ago. First Saturday I was home I pulled the K5 out of storage, fired it up and sent it to the shop for a new tranny rebuild. I'm suppose to pick it up after work today and hope to get to work on the body over the long weekend. Thanks for your knowledge and it's good to be back home in the land of the free! Mac '72 CST Blazer

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.