New Project! 67 Extended cab... - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Rokcrln · 08-28-2005, 04:41 PM

Fun times begin

Started on the pass side today. First I hamered the rear corner back into as good of shape as I could then welded it all up. Next I started on the front post. The more I dug the more I found and this is where it is right now. I have the new inner panel formed, trimmed and painted where it will be behind any other panels. The new bottom post it self is almost done. After lunch I should have it all done and the new rocker in place. I will finish the floor monday or so.

Kevin

08-28-2005, 04:41 PM	#11
Rokcrln Senior Member Join Date: Jul 2005 Location: Winters Ca. 95694 Posts: 4,843	Fun times begin Started on the pass side today. First I hamered the rear corner back into as good of shape as I could then welded it all up. Next I started on the front post. The more I dug the more I found and this is where it is right now. I have the new inner panel formed, trimmed and painted where it will be behind any other panels. The new bottom post it self is almost done. After lunch I should have it all done and the new rocker in place. I will finish the floor monday or so. Kevin Attached Images

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.