Question for Gee Emm or other guru - The 1947 - Present Chevrolet & GMC Truck Message Board Network

red71cheyenne · 08-31-2005, 11:20 AM

I'm at the point of lining up my body lines, and I have a little problem. My drivers side door gap between the vent window frame and windshield is really tight. The passenger side is way loose. I have the doors lined up so the body lines are really close as far as horizontal, but I'm worried about the way the doors are fitting. Is there some way I can tweak the windshield frame to get it more square? Or even a suggestion as to how I can measure square on it? Tearing it down to parade rest may have been a mistake as far as realigning. Thanks for any help or suggestions. Jeff.

08-31-2005, 11:20 AM	#1
red71cheyenne Back in the sticks Join Date: Jan 2001 Location: Fordland, MO Posts: 3,188	Question for Gee Emm or other guru I'm at the point of lining up my body lines, and I have a little problem. My drivers side door gap between the vent window frame and windshield is really tight. The passenger side is way loose. I have the doors lined up so the body lines are really close as far as horizontal, but I'm worried about the way the doors are fitting. Is there some way I can tweak the windshield frame to get it more square? Or even a suggestion as to how I can measure square on it? Tearing it down to parade rest may have been a mistake as far as realigning. Thanks for any help or suggestions. Jeff. __________________ 1971 Cheyenne C-10 w/700R4 and Tuned Port Injection 1969 K5 Blazer w/Tuned Port 2010 2SS/RS Flaming Orange Camaro 2011 K1500 Suburban 2014 K1500 Pickup 2008 Nissan Altima? The wifes' hoopty

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.