Edelbrock Performer Intake Question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

72str8flush · 10-19-2005, 12:00 PM

I need some help. I was installing a new heater core last night (when I bought mine the old one wasn't hooked up, it was interlooped). When I went to install the 5/8" hose from the bottom of the core to the intake I found that the PO had put a 3/4" fitting there to do the interloop. Where can I get that fitting of proper 5/8" size? Or what are my options?

Sorry, I dont have any pictures but it is the hole on the passenger side of the water neck of the edelbrock intakes. Thanks in advance.

10-19-2005, 12:00 PM	#1
72str8flush Registered User Join Date: Aug 2005 Location: Tennyson, Indiana 47637 Posts: 137	Edelbrock Performer Intake Question I need some help. I was installing a new heater core last night (when I bought mine the old one wasn't hooked up, it was interlooped). When I went to install the 5/8" hose from the bottom of the core to the intake I found that the PO had put a 3/4" fitting there to do the interloop. Where can I get that fitting of proper 5/8" size? Or what are my options? Sorry, I dont have any pictures but it is the hole on the passenger side of the water neck of the edelbrock intakes. Thanks in advance. __________________ 72 Chevy Short Bed Fleet: 350/TH350 - Sold - Now trying to sell the parts that I have left over. _______________________ 2006 VW GTI

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.