Rust Holes in Frame - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Newby 69 GMC · 09-03-2002, 08:24 PM

Hey guys,

Anyone out there have experience repairing rust holes in a truck frame? I just found a bad spot in the frame of my truck and am looking for some advice. The hole is just ahead of the drivers side rear wheel (damn Canadian winters and road salt!). The hole is approx 10 inches long and just on the bottom inside wall of the frame (OK it is not on my 69 GMC, but I trust you guys).

Any help or warnings you guys can offer would be appreciated

(I am fully prepared for all the "eat your import" and "Jap Scrap" comments but we all have to get to work.)

Thanks

09-03-2002, 08:24 PM	#1
Newby 69 GMC Registered User Join Date: Aug 2002 Location: Oshawa, ON, CAN Posts: 40	Rust Holes in Frame Hey guys, Anyone out there have experience repairing rust holes in a truck frame? I just found a bad spot in the frame of my truck and am looking for some advice. The hole is just ahead of the drivers side rear wheel (damn Canadian winters and road salt!). The hole is approx 10 inches long and just on the bottom inside wall of the frame (OK it is not on my 69 GMC, but I trust you guys). Any help or warnings you guys can offer would be appreciated (I am fully prepared for all the "eat your import" and "Jap Scrap" comments but we all have to get to work.) Thanks __________________ Newby 69 GMC Also own 88 4X4 Toyota P/U 01 Toyota RAV 4

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.