![]() |
![]() |
#1 |
Senior Member
![]() Join Date: Oct 2001
Location: Edgerton OH USA
Posts: 631
|
Bent Spindle.
Well I was assembling my calipers on my stepside and when I got over to the left side the caliper wouldn't slide in. After much work and checking I discovered that the lower part where the caliper bolt goes through is bent not allowing the caliper to go on straight. It's off by about 3/16" compared to the right side that slides right on and is straight. I thought I would have this thing back on it's wheels today. It must have been hit at some time on the donor vehicle.
Does anyone happen to have a good stock left spindle for a '71-'72 C10 laying around? I'm done until I can find one. I'm using 2" ECE springs and am not too excited about tearing everything apart again to put on dropped spindles. I might consider it though if I could find some in 2" or less. Tom
__________________
'69 swb stepside in progress. '59 Corvette lifetime project |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|