Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
01-25-2006, 08:14 PM | #1 |
Registered User
Join Date: Dec 2004
Location: Saskatchewan, Canada
Posts: 1,371
|
Floor patch won't fit?
I am just getting ready to install my drivers side front floor patch panel, but it seems too wide. I was going to lay it overtop of the rusty one and trace around it, cut the old one out and weld the new one back in, but I can't because it looks to be an inch too wide. Can I trim the tranny hump side off it, as its not rusty there, or am I going about this all wrong?
__________________
1964 Chevy Short Fleet: Tornado 1972 Chevy C10: Fast Orange Secondaries Wide Open |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|