Clutch linkage question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

jmanz69 · 04-24-2002, 08:45 PM

I have a complete clutch linkage from a doner, but when I put the bell crank in place it seems way too close to the frame. I'm supposed to have a braket on the frame that the other ball attatches to right? The engine side has a bracket that bolts to my 327 with no problem, is there something I am doing wrong. Guy I got it from said it was out of a V8 truck. He was going to auto and I was going to 4-spd. Seemed like a good thing to get at the time. Any idea if I can buy a frame bracket anywhere? Also, any one have a diagram of how it all goes together? I had a Chiltons manual around, but it is missing now.

04-24-2002, 08:45 PM	#1
jmanz69 Careful, they attack... Join Date: Aug 2001 Location: Waterford, MI, USA Posts: 1,107	Clutch linkage question I have a complete clutch linkage from a doner, but when I put the bell crank in place it seems way too close to the frame. I'm supposed to have a braket on the frame that the other ball attatches to right? The engine side has a bracket that bolts to my 327 with no problem, is there something I am doing wrong. Guy I got it from said it was out of a V8 truck. He was going to auto and I was going to 4-spd. Seemed like a good thing to get at the time. Any idea if I can buy a frame bracket anywhere? Also, any one have a diagram of how it all goes together? I had a Chiltons manual around, but it is missing now.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.