crankshaft endfloat - .001"-.006" ya right!! - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Greubin · 03-25-2006, 07:11 PM

I pulled the th350 out of my truck to install the 700r4 today. While i was checking things out on the flexplate area, i checked the crank end float which I found to be about 1/16", forget about a few thou's of an inch

...I'm totally bummed. The engine runs strong - so now what do I do - I hate to pull the eng. at this point, I'm not ready for that. **** it, I'm installing the tranny throwing caution to the wind, may the engine gods have mercy!!

I'm pulling the damn thing - better to do it right than be sorry in the long run.

03-25-2006, 07:11 PM	#1
Greubin Registered User Join Date: Dec 2005 Location: SJC Posts: 158	crankshaft endfloat - .001"-.006" ya right!! I pulled the th350 out of my truck to install the 700r4 today. While i was checking things out on the flexplate area, i checked the crank end float which I found to be about 1/16", forget about a few thou's of an inch ...I'm totally bummed. The engine runs strong - so now what do I do - I hate to pull the eng. at this point, I'm not ready for that. **** it, I'm installing the tranny throwing caution to the wind, may the engine gods have mercy!! I'm pulling the damn thing - better to do it right than be sorry in the long run. __________________ ___________ Greubin '71 C20 custom - GM Crate 350CI/290HP, BTO 700R4 level II, Qjet, and HEI Last edited by Greubin; 03-26-2006 at 02:16 AM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.