taking fender off a step side bed - The 1947 - Present Chevrolet & GMC Truck Message Board Network

qksilver · 03-26-2006, 12:40 AM

Been in the shop stripping a few truck that were given to me. Working on a step side bed and wondering if there are any tricks to getting the fenders off. I have sprayed them down for the past couple of days.
There is a phillips screw head on the inside of the bed and regular nuts in the fender well. I can't screw them out. I can't hold the screw driver when i turn the nuts, it just twists too much. It is a great bed so I don't want to use a torch to burn off the nuts.
Thanks,
Steve

03-26-2006, 12:40 AM	#1
qksilver Senior Member Join Date: Dec 2004 Location: Southern Pines NC Posts: 3,853	taking fender off a step side bed Been in the shop stripping a few truck that were given to me. Working on a step side bed and wondering if there are any tricks to getting the fenders off. I have sprayed them down for the past couple of days. There is a phillips screw head on the inside of the bed and regular nuts in the fender well. I can't screw them out. I can't hold the screw driver when i turn the nuts, it just twists too much. It is a great bed so I don't want to use a torch to burn off the nuts. Thanks, Steve

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.