![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Jun 2004
Location: Saskatchewan, Canada
Posts: 1,368
|
Time to get busy on new motor install.
Weathers nice and it's time to get some work done. Mocked up a few peices today, notched my header flanges to fit ARP fasteners ( not sure why Hooker dosn't address this problem ). Installed TCI flexplate and shimmed starter, wanted to install my March pullies and measure for belts, but found out my TCI dampner has fine thread holes. Decided to finish off with some pics instead of cleanning up.
![]()
__________________
Speed is just a matter of money, question is how fast can you afford to go? 8.95@148.97mph all motor haven't tried bottle yet Sponsored by: Getz Oilfield Consulting Hard Candy Customs |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|