|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
10-04-2002, 01:30 AM
|
#1 |
|
Registered User
Join Date: Jul 2000
Location: Chandler, Arizona, USA
Posts: 299
|
Holley Carb to a Edelbrock Manifold
I have an Edelbrock Performer manifold, spread-bore i believe, need to run a 750 holley for the motor (I know the manifold is not the right one for the motor..just all I have to deal with right now), will the carb fit to the manifold without an adapter? I had a Carter AFB on it before, believe it was square bore and it ran just fine. had a square bore gasket on it..acted like a adapter I think? Any advice would help...thanks guys!
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode