![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Apr 2006
Location: Ontario, Canada
Posts: 75
|
Rochester Monojet Help
Hi Guys, I just got my truck and I'll be the first to admit I'm a bit of a "tool" when it comes to mechanical expertise, however, I'm usually brave enough to try
![]() I'm planning on replacing my inline six at some point but for now I want to get it running smooth. Hoping you guys could give me a hand? The Problem: It's REAL hard to get going. If I just feather on the gas I can get it to catch after about 15 starting attempts. If I let it idle for about 5 mins I can gradually apply more gas very slowly and raise the RPMs. Too much gas and it stalls out. After its up to tempature I can drive it. The Equipment: 1970 Chev Rochester MonoJet for an inline 6. 250cc. Casting number# 7040021 What I think is wrong: I think it's the choke. I've never seen a carb like this before it doesn't have a choke on it? I think it's detached? (See pic) ![]() . ![]() The Solution: (and here's where I need your help) * I can't seem to find a replacement choke (rebuild kits yes, chokes, no). Anybody point me in the right direct here? * Is there another carb I could buy that would work on the inline 6 with the choke incorporated? Remember the engine is going likely in the next 12 months [It would have to be low $$$ solution] and there looks to be a fairly elaborate mechanism to operate the specific carb on there now. Looks like anything else (newer) would require from creative fabrication. ![]() * Has anybody ever hooked up a manuel choke under the dash for this carb? I'd appreciate your input and advice of what you feel might be the easiest way to fix this.....Thanks Ps: New points and wires....I think its definately an air/fuel thing.
__________________
If you keep and open mind you never know what might drop in. ![]() 1970 Chev C10 SWB, "250 turbo thrift" ![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|