Can't get it in 1st or second - The 1947 - Present Chevrolet & GMC Truck Message Board Network

69chevytruck · 07-26-2006, 07:16 PM

I have a t-5 out of an s-10 and it was working fine. The z bar slipped so the clutch was misligned, but that has been fixed. Now I can not get it into first, second (shifterdoes not move into position) or reverse (grinds the gears) with the engine running. I can put it in gear, start the engine and move, but can not shift. I have adjusted the clutch to both extemes and no luck. I have fluid, the trans has about 3,000 miles on it. I can get it into 3rd and 4th.

Can anybody help me out here?

07-26-2006, 07:16 PM	#1
69chevytruck Registered User Join Date: Dec 2004 Location: Little Rock, Arkansas Posts: 38	Can't get it in 1st or second I have a t-5 out of an s-10 and it was working fine. The z bar slipped so the clutch was misligned, but that has been fixed. Now I can not get it into first, second (shifterdoes not move into position) or reverse (grinds the gears) with the engine running. I can put it in gear, start the engine and move, but can not shift. I have adjusted the clutch to both extemes and no luck. I have fluid, the trans has about 3,000 miles on it. I can get it into 3rd and 4th. Can anybody help me out here? __________________ 1969 C-10,short bed, I6 250, 3x1 offy, HEI, headers, 5 speed, original paint and family owned!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.