Look what I found, What do you think it's worth???

[ChevyDude]

Well with my 71' approaching completion and me as obsessed and sick about these trucks, I'm always looking for that good deal. I just stumbled on this truck and am going to see it on Wed. Here is what the owner sent me:

1967 C-10 Stepside Project. Frame and running gear all assembled Needs minor body work and assembly, all parts there. For Sale or Trade

I bought one 67 C-10 to get a step side frame, bed and running gear; and another 67 to get a decent cab, front clip, hood. ($400 for each)

Frame and Running Gear

Frame, rear end, front crossmember, upper and lower control arms, trans mount, trailing arms, radiator support, and splash pans completely sandblasted, primed and painted with black implement paint. ($250)

Complete 1974 crossmember installed with disc brakes, calipers, and power steering box, proportioning valve replacing original. ($250)

New upper and lower ball joints, inner and outer tie rod ends, and front end bushings. Rotors turned with new disc brake pads, new inner and outer packed wheel bearings. ($200)

New front brake caliper hoses. (LMC $40)

New tranny mount ($15) and SBC engine towers and mounts ($15)

New body, bed, and radiator support mounts. (LMC $159)

Front spring trimmed one coil with cutoff wheel (not torch)

Three new drive shaft universal joints and pilot bearing ($50)

3.73 : 1 12 bolt rear with new trailing arm bushings. (LMC $30)

New 4” dropped rear coil springs ($125) and new rear end u-bolts. (LMC $45)

New rear brake shoes, turned drums, rebuilt wheel cylinders ($60)

Rear axles re-drilled to 5 on 5” with new axle bearings and lug studs. ($180)

Four classic 5 x 5 mag wheels just added (Would need tires)

CAB & BED

One cab corner and both rocker panels replaced

Step side bed and wood slat supports disassembled and sandblasted