NEED HELP! front end vibration - The 1947 - Present Chevrolet & GMC Truck Message Board Network

toddtheodd · 09-07-2006, 07:45 AM

1972 c10 1/2 ton, 2wd longbed, with front swaybar from a 1-ton.
I've replaced the entire front suspension, balljoints, tie rods and ends, control arm shafts, and I've replace the bearings inner and outer, and shocks.
It's only the front left wheel.
When I take a hard right turn, at around 45 mph plus, I can feel a vibration. And when I get over 75 mph in a straight line, I can feel it again. I know it's not the front right, because left turns don't vibrate.
Also, when I hit a decent size bump (over 20mph) on the left side, the front wheel kinda makes a clunking noise.
What could it be?
Toad

09-07-2006, 07:45 AM	#1
toddtheodd The oddest Todd around Join Date: May 2004 Location: Miami, Florida Posts: 1,418	NEED HELP! front end vibration 1972 c10 1/2 ton, 2wd longbed, with front swaybar from a 1-ton. I've replaced the entire front suspension, balljoints, tie rods and ends, control arm shafts, and I've replace the bearings inner and outer, and shocks. It's only the front left wheel. When I take a hard right turn, at around 45 mph plus, I can feel a vibration. And when I get over 75 mph in a straight line, I can feel it again. I know it's not the front right, because left turns don't vibrate. Also, when I hit a decent size bump (over 20mph) on the left side, the front wheel kinda makes a clunking noise. What could it be? Toad __________________ "The greatest pleasure is to vanquish your enemies and chase them before you, to rob them of their wealth and see those dear to them bathed in tears, to ride their horses and clasp to your bosom their wives and daughters." Ghengis Khan IIOY??? Last edited by toddtheodd; 09-07-2006 at 07:47 AM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.